Lehké slitiny

Oblast zaměření: Lehké slitiny
Komise : CEN/TC 132 (Aluminium and aluminium alloys)
Původce: CEN
K připomínkám do: 25.03.2019
Zobraz více Zobraz méně
 

This document specifies a gravimetric method for determining the mass per unit area (surface density) of anodic oxidation coatings on aluminium and its alloys.

The method is applicable to all oxidation coatings formed by anodizing aluminium and its alloys, either cast or wrought, and is suitable for most aluminium alloys, except those in which the copper content is greater than 6 %.

NOTE 1       A high content of copper in the alloy can lead to increased dissolution of the basis aluminium.

NOTE 2       If the thickness is known with sufficient precision (for example, using the method specified in ISO 2128, (1)), determination of the mass per unit area (surface density) of the coatings will enable its apparent density to be calculated. Conversely, if the conditions of application of the coating and its density are known, the determination of its mass per unit area (surface density) can permit calculation of the average mass and an approximate evaluation of the thickness (see the Note in Clause 9).

Oblast zaměření: Lehké slitiny
Komise : CEN/TC 132 (Aluminium and aluminium alloys)
Původce: CEN
K připomínkám do: 2.04.2019
Zobraz více Zobraz méně
 

This document defines the requirements for grades of alloyed aluminium ingots intended for remelting.

It specifies the classifications and designations applicable to these grades, the conditions in which they are produced, their properties and the marks by which they are identified.

Oblast zaměření: Lehké slitiny
Komise : CEN/TC 132 (Aluminium and aluminium alloys)
Původce: CEN
K připomínkám do: 2.04.2019
Zobraz více Zobraz méně
 

This document specifies the chemical composition limits for aluminium casting alloys and mechanical properties of separately cast test pieces for these alloys.

Annex C is included as a guide to the selection of alloys for a specific use or process.

This document is intended to be used in conjunction with EN 576, EN 1559‑1, EN 1559‑4, EN 1676 and EN ISO 8062‑3.