Světelné zdroje a svítidla

Oblast zaměření: Světelné zdroje a svítidla
Komise : IEC/TC 34 (Lamps and related equipment)
Původce: ISO\IEC\CEN\CENELEC
K připomínkám do: 22.10.2019
Zobraz více Zobraz méně
 

This document specifies methods of measurement of electrical power consumption in non-active mode(s), as applicable for electrical lighting equipment. This includes electrical lighting equipment incorporating non-illumination components.

This document specifies neither performance requirements nor limits on power consumption.

This document applies to lighting equipment connected to a supply voltage up to 1500 V DC or up to 1000 V AC.

Oblast zaměření: Světelné zdroje a svítidla
Komise : IEC/TC 34 (Lamps and related equipment)
Původce: ISO\IEC\CEN\CENELEC
K připomínkám do: 3.12.2019
Zobraz více Zobraz méně
 

This document describes a method, based on measurements combined with calculations, to determine specific characteristics of the inrush current of single and/or multiple lighting products of the same type. Lighting products include the following:

•        Light sources with integrated controlgear,

•        Controlgear,

•        Luminaires.

The inrush current characteristics that are determined are

•        the peak inrush current,

•        the inrush-current pulse duration.

This Document applies to lighting products connected to low-voltage 230 V AC 50/60 Hz electrical supply networks.

NOTE - In clause 6 it is stated that the methodology applies reference values for the reference (line) inductance and the reference (short circuit) peak current which reflect the typical situation in a 230 V AC installation.

Oblast zaměření: Světelné zdroje a svítidla
Komise : IEC/SC 34D (Luminaires)
Původce: ISO\IEC\CEN\CENELEC
K připomínkám do: 17.12.2019
Zobraz více Zobraz méně
 

This part of the IEC 60598-2 specifies requirements for extra low voltage lighting systems for ELV light sources, intended for ordinary interior use on supply voltages not exceeding 1000 V. The luminaires, being connected in parallel, are supplied via freely suspended continuous supporting conductors or profiles. The current in the ELV part of the system not exceeding 25 A.